Personal Fireplace
What you'll need:
Add some ambiance to your outdoor party with a personal fireplace.
Other Supplies
  Shallow Metal Bucket
  Wire Mesh
  Gel Fuel
  Stones
Step-by-step instructions
Step 1
Lay your wire mesh on the ground and place your bucket upside-down over the grate. Using a brightly colored grease pen, trace the bucket.
Step 2
Using your Rotary tool with Sheild attachment and the 426 Cutting wheel, cut the wire mesh 1/2" shorter than the diameter of your bucket.

Tip: Whenever cutting metal, be sure to wear gloves, as your workpiece may spark. These sparks can be deflected using the Dremel A550 shield attachment. To install the Sheild Attachment, remove the nosepiece of your rotary tool and replace it with the attachment. The clear shield rotates around the nose piece so adjust where needed to best deflect sparks. When cutting metals, start your Variable Speed Rotary off at a low speed and increase as needed. If chattering occurs on your metal workpiece, increase the speed of your tool gradually until the cut is smooth. Cutting wheels may wear throughout the project, so have a few on hand just in case you need to switch out wheels. If necessary, make additional quick cuts to remove any jagged edges.
Step 3
Place your bucket upright and set the gel fuel inside the bucket. Place the cut piece of mesh about an inch down inside the bucket, leaving enough room to add stones on top, that's it!
© 2014 Ace Hardware Corporation. Ace Hardware Corporation and Ace Hardware Corporation logo are registered trademarks of Ace Hardware Corporation
HACKER SAFE certified sites prevent over 99% of hacker crime.

Add Item to To-Done List

To use this feature you must be signed-in to your account, please sign in now. If you do not have an account, please create an account to participate.

Ace Rewards

Ace Rewards is a free and rewarding membership program that lets you earn rewards with every purchase you make! Join now.